Long-Term Potential for New Breed of Gas Sensors

December 4, 2009 By sensortipsadmin Leave a Comment

It was not so long ago that gas detection was biological, and canaries were the state-of-the art gas detectors. Until well into the 20th century the little birds were used to detect build-ups of deadly carbon monoxide in mines and thus saved the lives of thousands of miners.
The canaries were retired when electro-chemical sensors were developed to monitor chemical processes and measure variables, such as resistance, to detect the build up of gases. Despite the refining of the technology over a period of many years, this way of sensing gas emissions is unsatisfactory in several ways – not least the time it takes.
What was needed was a new type of sensor, based on new technologies, which could very quickly detect and identify any special or unusual gas build up in the ordinary ambient air and either sound the alarm or institute corrective measures.
A cross-disciplinary EU-funded project,NEMIS, was set up to study the problem and develop a working model of a new type of optical sensor based on recent advances in laser technology and photonics.
New type of laser
Specifically, the researchers worked to develop a system based on a new type of laser with a range of characteristics suited to detecting gases, other than those naturally occurring in air, at room temperature.
The vertical-cavity, surface-emitting semiconductor laser diodes (VCSELs) which were used to drive the NEMIS photonic sensing system for trace gas analysis allow for the construction of robust, long-lasting and low-cost sensors.
The advantages of using VCSELs rather than conventional lasers, apart from cost-efficiency, are that you can tune the wavelength more broadly. Usually a laser can only be tuned over less than a nanometre by changing the electrical current, but a VCSEL has the ability to tune over more than five nanometres.
Because the sensor is looking for anomalies in wavelengths to detect gas – in the case of the pilot study with the gas being carbon monoxide (CO) – laser ‘tunability’ allows for both greater flexibility and the ability to create a self-contained, sealed sensor.
Each gas has a unique “absorption line” which allows the laser to detect its presence, so if the laser can be tuned up and down it means a series of lines representing different gases can be detected by a single sensor.
Self-calibrating sensors
It also means that self-calibrating sensors, which continuously check against a sample of gas at a pre-set or known wavelength, before going to a different absorption line to take measurements for CO and other gases, become practical.
As the sensors are self-calibrating there is no need for human interaction and they can be sealed in tough containers which not only have a life of many years but can also be put into hostile environments in industrial installations without suffering corrosion.
Perhaps the biggest challenge for NEMIS was the wavelength. No laser was able to do what they wanted done at the wavelength range they had to work at – 2 to 3.5 µm – had been developed. So one of the main achievements of the project has been to develop lasers that are suitable for optical gas sensing.
Once the researchers had done their bit, the project’s industrial partners developed a demonstrator which initially was able to detect CO NH3 (ammonia). Sensors for other gases including carbon dioxide (CO2) and hydrogen sulphide (H2S) are under development.

Leave a Reply

You must be logged in to post a comment.